Msd 7530T Programmable Digital-7 Ignition Control Manuel d'utilisateur télécharger pdf

A short red wire with bullet connectors on each end and a 20-ohm resistor is supplied with this

Ignition Control. This jumper wire may need to be installed in series on the small red ignition (on/

off) wire when the battery input voltage is over 14 volts.

When the optional Launch Control, PN 7551, or Hand Held Monitor, PN 7550, are left connected to

the Programmable 7-Series Ignition Control and the ignition receives over 14 volts, the unit may

shut down. This resistor jumper wire will prevent that from occurring by lowering the input voltage.

This will not affect the output of the ignition (which gets its supply voltage directly from the battery).

MSD has already incorporated this change in the ignitions. If your ignition has an R1 or R2

stamp on the end panel, you will not need the Resistor wiring. Also, if you are not using the

Hand Held Monitor or one of the Launch Controls, the resistor jumper wire is not required.

PROGRAMMAGLE DIGITAL-7 SERIES IGNITIONS

PN 7530T, PN 7535, PN 7531, PN 75314

AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344

Printed In U.S.A.

A short red wire with bullet connectors on each end and a 20-ohm resistor is supplied with this

Ignition Control. This jumper wire may need to be installed in series on the small red ignition (on/

off) wire when the battery input voltage is over 14 volts.

When the optional Launch Control, PN 7551, or Hand Held Monitor, PN 7550, are left connected to

the Programmable 7-Series Ignition Control and the ignition receives over 14 volts, the unit may

shut down. This resistor jumper wire will prevent that from occurring by lowering the input voltage.

This will not affect the output of the ignition (which gets its supply voltage directly from the battery).

MSD has already incorporated this change in the ignitions. If your ignition has an R1 or R2

stamp on the end panel, you will not need the Resistor wiring. Also, if you are not using the

Hand Held Monitor or one of the Launch Controls, the resistor jumper wire is not required.

PROGRAMMAGLE DIGITAL-7 SERIES IGNITIONS

PN 7530T, PN 7535, PN 7531, PN 75314

AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344

Printed In U.S.A.

Résumé du contenu

Page 1

A short red wire with bullet connectors on each end and a 20-ohm resistor is supplied with thisIgnition Control. This jumper wire may need to be insta

Commentaires sur ces manuels

Pas de commentaire

Msd 7530T Programmable Digital-7 Ignition Control Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Msd 7530T Programmable Digital-7 Ignition Control. MSD 7530T Programmable Digital-7 Ignition Control User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Msd 7530T Programmable Digital-7 Ignition Control