Msd 2346 Universal Sync Signal Kit Installation Manuel d'utilisateur télécharger pdf

Parts Included:

1 - Non-Magnetic Pickup 1 - Magnet 1 - Magnet Collar

The Universal Sync Signal Kit, PN 2346, is primarily used to provide a cam sync to EFI or other engine

control units that require a signal for cylinder 1 ﬁring. This kit includes the non-magnetic pickup and

magnet only and requires mounting fabrication work for installation.

The sensor can be set to pulse at the leading or trailing edge of the signal depending on which pole of

the magnet faces the pickup. To determine the poles of the magnet, use either another magnet that is

marked North and South, or use a compass to point toward the North pole of the magnet. The south

end of the compass will point to the North pole of your magnet. When the North pole of the magnet

faces the pickup the signal will pulse on the trailing edge. When the South pole of the magnet faces

the pickup the pulse will be on the leading edge of the signal.

The magnet requires a 0.250” dia. hole. If the magnet is to be pressed in it should be prepared as 0.248

+/- 0.0005. If the magnet is not pressed in it should be secured with an epoxy inside the hole of a 0.25”

mill bit. The magnet is 0.20” deep. If the magnet is to be mounted in a steel rotational assembly the

supplied aluminum sleeve is required to prevent diffusing the magnet in the assembly. The aluminum

sleeve requires a prepared hole measuring 0.375” +/- 0.0005 or a 0.375” bit, respectively.

The threads on the non-magnetic pickup measure ½ - 20. A 27/64” bit should sufﬁce to prepare for

the ½-20 tap.

In order to properly set the air gap for the non-magnetic pickup users should aim for 0.050”space. In

many cases the pickup and magnet are in places that make it difﬁcult or impossible to measure air

gap – when this happens the user can get close to the measurement with a few simple steps:

1) Thread the pickup to bottom out on (touch) the magnet.

2) Turn the pickup back out of the threads one full rotation.

3) Carefully spin the engine so that the magnet goes past the pickup a few times to check that there

is no interference.

MSD Universal Sync Signal Kit

PN 2346

M S D • W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4

ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered

in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product

will help if there is ever a warranty issue with your product and helps the MSD R&D team create

new products that you ask for! Go to www.msdperformance.com/registration.

1 2

Parts Included:1 - Non-Magnetic Pickup 1 - Magnet 1 - Magnet CollarThe Universal Sync Signal Kit, PN 2346, is primarily used to provide a cam sync t

Limited Warranty MSD warrants this product to be free from defects in material and workmanship under its intended normal use*, when properly installe

Pas de commentaire

Msd 2346 Universal Sync Signal Kit Installation Manuel d'utilisateur