Msd 64602 6M-2 to GM Dual Connector Harness Installati Manuel d'utilisateur télécharger pdf

MSD 6M-2/MSD Off-Road Ignition

To GM Dual Connector Coil Harness

PN 64602

WARNING: During installation, disconnect the battery cables. When disconnecting, always

remove the negative cable ﬁrst and install it last.

Parts Included:

1 - Harness 1 - Instruction Maunal

This harness is designed to provide a splice free and simple installation of an MSD 6M-2

Marine Ignition Control, PN 6460, or MSD 6-Offroad Ignition, PN 6470 to engines equipped

with GM's dual Connector Coil (Figure 1).

Note: In some cases, an MSD Tach/Fuel Adapter may be required for correct tachometer

and fuel injection operation, there is also a connector for the Adapter, PN 8910.

All of the connectors plug directly into the corresponding connectors on the ignition and coil

(Figure 1).

1. Disconnect the Gray connector followed by the Black connector from the coil.

2. Connect the Black then the Gray connector to the MSD PN 64602 Harness.

3. Connect the other end of the harness to the coil. Note: the connector will only ﬁt on one side

of the coil. Only two wires go to the coil with an MSD Ignition Control installed.

4. Connect the 6-Pin Weathertight connector to the MSD Control.

5. If your application requires an MSD Tach/Fuel Adapter, Connect the remaining 2 Black wires

to the MSD Adapter.

Figure 1

M S D • W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4

1 2

MSD 6M-2/MSD Off-Road IgnitionTo GM Dual Connector Coil HarnessPN 64602WARNING: During installation, disconnect the battery cables. When disconnectin

Limited Warranty MSD warrants this product to be free from defects in material and workmanship under its intended normal use*, when properly installe

Pas de commentaire

Msd 64602 6M-2 to GM Dual Connector Harness Installati Manuel d'utilisateur