Msd 84085 Cap_Rotor Kit (8408, 8423) Installation Manuel d'utilisateur télécharger pdf

WARNING: Disconnect the battery during installation. When disconnecting the battery, always

remove the negative cable ﬁrst and install it last.

Figure 2 Washer Installation.

MSD Rotor, PN 8423

Fits MSD Cap-A-Dapt, PN 8445 and PN 8441

also, MSD Distributors with Cap PN 8408

Parts Included:

1 – Rotor, PN 8423

2 – 5/8” Phillips Head Screws

IMPORTANT: There are two different length screws supplied with this rotor. It is important to determine

which screws are correct for your application due to clearance of the magnetic pickup.

Remove the cap, rotor and the cap spacer and note the rotor screw retainer that is installed on the

bottom of the advance plate (Figure 1). There are two styles used; one is a Screw Retainer, the other

is a Retainer with a Nut. The Retainer accepts the shorter 5/8” screw while the Nut version accepts

the ¾” screw.

Once the rotor screw length is determined, install the rotor being

sure the round and square aligning pegs are lined up correctly. Install

the Belleville washers with the dome facing up on the screws and

tighten the rotor (Figure 2). Install the cap and plug wires.

Figure 1 Determining Rotor Screw Length.

Note: It is recommended to install the rotor and check the

clearance before reassembling the distributor.

ROTOR SCREW

RETAINER

ROTOR SCREW

RETAINING NUT

USE 5/8"

SCREW

USE 3/4"

SCREW

2 – 3/4” Phillips Head Screws

2 – Belleville Washers

M S D I G N I T I O N • w w w . m s d i g ni t i o n . c o m • ( 9 15 ) 85 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4

1 2

WARNING: Disconnect the battery during installation. When disconnecting the battery, always remove the negative cable ﬁrst and install it

Limited Warranty MSD IGNITION warrants this product to be free from defects in material and workmanship under its intended normal use*, when properly

Pas de commentaire

Msd 84085 Cap_Rotor Kit (8408, 8423) Installation Manuel d'utilisateur