Msd 8468 Vacuum Advance Lockout, PN 8360, 8361, 8572 Manuel d'utilisateur télécharger pdf

M S D • W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4

1. Remove the two Allen head screws that hold

the advance canister (Figure 1).

2. Remove the snap ring that holds the magnetic

pickup assembly in place. This is easy to do

with a set of snap ring pliers by straddling one

of the reluctor paddles.

3. Gently lift up on the mag pickup plate and slide

the vacuum canister out.

4. Install the Lockout Plate in place of the

canister. Install the two retaining screws but

do not tighten at this time.

5. Install the supplied self tapping screw and

washer through the Lockout and tighten. It

is important to make sure the pickup plate

is parallel with the housing of the distributor

(Figure 2). If it is cocked or slanted, the paddles

of the reluctor may contact the pickup. Check

the clearance by rotating the distributor shaft.

If necessary, use the supplied shims under the

Lockout hold-down to correctly position the

pickup plate.

Vacuum Advance Lockout

PN 8468

If you do not want to use the vacuum advance canister of the MSD Distributor, MSD has supplied

the distributor with a lockout mechanism. The Lockout bolts in the position of the vacuum canister

and will hold the pickup assembly ﬁrmly in place. The installation is easiest with the distributor out

of the engine.

RELUCTOR PADDLES

MAG PICKUP PLATE

CANISTER SCREWS

SNAP

RING

RELUCTOR

PADDLES

MAG PICKUP

PLATE

MAG PICKUP PLATE AND

HOUSING MUST BE

PARALLEL.

(SHIM IF NECESSARY)

DISTRIBUTOR HOUSING

LOCKOUT PLATE

IF NECESSARY,

SHIM HERE

LOCKOUT

SCREW/WASHER

Figure 1 Removing the Vacuum Canister.

Figure 2 Checking Installation of the Lockout Plate.

Note: If no shims were required, use one beneath the washer of the Lock-Out Hold Down Screw.

1 2

Résumé du contenu

Page 1 - Vacuum Advance Lockout

M S D • W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 41. Remove the two A

Page 2 - SNAP RING

LOCKOUT PLATELOCKOUTHOLD-DOWNSNAP RINGFigure 3 Installation of the Vacuum Lockout Plate.6. After checking the reluctor to pickup clearance, tigh

Commentaires sur ces manuels

Pas de commentaire

Msd 8468 Vacuum Advance Lockout, PN 8360, 8361, 8572 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Msd 8468 Vacuum Advance Lockout, PN 8360, 8361, 8572. MSD 8468 Vacuum Advance Lockout, PN 8360, 8361, 8572 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Msd 8468 Vacuum Advance Lockout, PN 8360, 8361, 8572