Msd 8728 Soft Touch Rev Control Manuel d'utilisateur télécharger pdf

Cylinder Select Device

This MSD product is set for 8-cylinder operation at the factory.

To reprogram this MSD product for 4 or 6 cylinder operation,

ﬁnd the Cylinder-Select Device (Figure 1) on the unit panel and

remove the Phillips screw holding the cover.

The Cylinder-Select Device has a Red and a Blue wire loop

which are used for programming the unit for 4 or 6 cylinder

operation. Cut the loops as described below for the number

of cylinders on the engine.

8-cylinder: Do not cut any loops

6-cylinder: Cut only the Red loop

4-cylinder: Cut both the Red and Blue loops

After cutting the loops turn the cut wire ends away from each

other so that they will not short out to each other (Figure 2).

Be sure to reinstall the cap onto the Cylinder-Select Device and secure with the Phillips screw.

Figure 1

Figure 2

M S D • W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4

© 2012 Autotronic Controls Corporation

FRM28468 Revised 12/11 Printed in U.S.A.

Cylinder Select Device

This MSD product is set for 8-cylinder operation at the factory.

To reprogram this MSD product for 4 or 6 cylinder operation,

ﬁnd the Cylinder-Select Device (Figure 1) on the unit panel and

remove the Phillips screw holding the cover.

The Cylinder-Select Device has a Red and a Blue wire loop

which are used for programming the unit for 4 or 6 cylinder

operation. Cut the loops as described below for the number

of cylinders on the engine.

8-cylinder: Do not cut any loops

6-cylinder: Cut only the Red loop

4-cylinder: Cut both the Red and Blue loops

After cutting the loops turn the cut wire ends away from each

other so that they will not short out to each other (Figure 2).

Be sure to reinstall the cap onto the Cylinder-Select Device and secure with the Phillips screw.

Figure 1

Figure 2

M S D • W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4

© 2012 Autotronic Controls Corporation

FRM28468 Revised 12/11 Printed in U.S.A.

1

Cylinder Select Device 1

Résumé du contenu

Page 1 - Cylinder Select Device

Cylinder Select DeviceThis MSD product is set for 8-cylinder operation at the factory. To reprogram this MSD product for 4 or 6 cylinder operation, ﬁn

Commentaires sur ces manuels

Pas de commentaire